• Structural Optimization for Excessive Injection Mold Gate Residue

  Gate residue is a common molding problem in injection production, referring to excess plastic protrusions at the product glue inlet. Excessive gate residue requires manual trimming, increases producti

  2026/09/08 Injection Molding

• Effective Control Measures to Extend Service Life of Injection Molds

  Injection molds are high-cost core equipment in plastic manufacturing, and their service life directly affects production efficiency, product quality and manufacturing cost. Most molds suffer from pre

  2026/09/08 Injection Molds

• Common Defects and Improvement Solutions of PC Injection Molding in Chinese Plastic Molds

  In the manufacturing system of Chinese plastic molds, PC material is widely adopted for transparent components, electronic housings, structural accessories and home‑appliance parts for its high transp

  2026/09/07 Chinese Plastic Molds

• Complete Troubleshooting Analysis of Short Shots in Injection Molding

  Short shot, also known as insufficient filling, is one of the most common defects in injection molding production, which is manifested as incomplete filling of product edges, unfilled thin walls, miss

  2026/09/07 Injection Molding

• Differences Between Injection Mold Opening and 3D Printed Prototypes and Phase Selection Suggestions

  In the iterative development of plastic products, 3D printed prototypes and injection mold opening are the two core methods for sample verification and mass production landing. Most enterprises are pr

  2026/09/07 Plastic Molds

• Factors Affecting Plastic Mold Design Fees

  Plastic mold design is the core link in the early stage of mold development. The rationality of the design scheme directly determines the later processing difficulty, molding stability and mold modifi

  2026/09/07 Plastic Mold

• Differences in Hygiene Standards Between Food‑Grade Injection Molds and Conventional Molds

  Food‑grade injection molds manufacture plastic parts that directly contact food. Mold material, surface condition and maintenance mode will influence food‑contact safety of finished products. Conventi

  2026/09/04 Injection Mold

• Mold Carbon Deposit Cleaning and Prevention Measures for Flame‑Retardant ABS Production

  Flame‑retardant ABS contains halogen or halogen‑free flame‑retardant additives. Under continuous high‑temperature shear conditions, additives tend to decompose. Small‑molecule precipitates adhere to m

  2026/09/04 Injection Molding