• How to Fix Sink Marks on Injection‑Molded Parts: Dual Optimization of Process and Mold

  Sink marks and local depressions are common defects of injection‑molded products, mostly appearing at thick‑wall positions, bosses and rib junctions. Light sink marks affect surface appearance, while

  2026/08/26 Injection Molding

• Key Design Considerations for Injection Molds of Plastic Fasteners

  Plastic fasteners cover plastic screws, nuts, snap‑fit components and threaded inserts, widely used in home appliances, new‑energy products and consumer electronics. These structural parts require str

  2026/08/26 Injection Mold

• Analysis of Mold‑Sticking Causes and Mold Modification Solutions for Injection‑Molded Products

  Mold sticking means molded parts or cold sprue slugs adhere to mold surfaces and cannot detach smoothly during demolding. This common trouble interrupts normal cyclic production. Operators have to sto

  2026/08/25 Injection Mold

• Core Process Differences Between Injection Molding and Extrusion Molding

  Both injection molding and extrusion molding belong to major thermoplastic processing technologies. Both processes heat plastic for melting and utilize screws for plasticizing and material conveying.

  2026/08/25 Injection Molding

• Causes and Improvement Solutions for Floating Glass‑Fiber Defects in Injection‑Molded Parts

  Floating glass fiber is a typical surface defect for glass‑fiber‑reinforced injection molded plastics. Exposed glass fibers appear as white dots and fine fibrous hairs on component surfaces. Such flaw

  2026/08/25 Injection‑Mold

• Key Considerations for Mold Design in Fully‑Automatic Injection Molding Workshops

  Fully‑automatic injection molding workshops rely on manipulators, conveyor belts and assembly lines to achieve low‑manpower continuous production. Molds for automated production place stricter require

  2026/08/25 Injection Molding

• China Plastic Molds: Material Selection and Key Processing Points for POM Injection Molds

  POM, also known as acetal or polyoxymethylene, is a high‑performance crystalline engineering plastic widely applied for gears, sliding parts and structural connectors. It features high hardness, low f

  2026/08/24 China Plastic Molds

• Solutions for Common Flash Defects of Molded Plastic Threaded Parts

  Threaded plastic components such as bottle caps, pipe fittings and sealing connectors demand strict thread precision. Flash occurring on thread tooth gaps, parting lines and core‑pulling joint surface

  2026/08/24 Plastic Molds