• Cost Reduction Strategies for Molds Supported by Injection Molding Structural Optimization

  As competition intensifies in plastic product projects, investment in molds and mass production processing costs keep rising. Simply cutting mold processing expenses will easily shorten mold service l

  2026/07/24 Injection Molding

• Mold Customization Specifications for Flame-Retardant ABS+PC Alloy

  Flame-retardant ABS+PC alloy integrates the favorable flowability of ABS and the high strength and heat resistance of PC. After incorporating flame retardant additives, its thermal stability, melt cha

  2026/07/24 Plastic Molds

• Rectification Plan for Part Warpage Induced by Blocked Mould Cooling Channels

  After long-term operation, limescale, rust and microbial sludge build up inside mould cooling channels, reducing pipeline cross-section and creating local blockages. Heat exchange capacity becomes une

  2026/07/23 Injection Molds

• Key Design Points of Energy-Saving Mass-Production Hot Runner Injection Moulds

  Hot runner moulds maintain plastic melt inside manifolds and nozzles through continuous heating, eliminating cold runner waste. They feature high material utilization and shortened molding cycles in h

  2026/07/23 Injection Moulds

• Design of Anti-Deformation Reinforcement for Large Flat Plastic Parts in Chinese Plastic Moulds

  Large flat plastic parts are widely produced by Chinese plastic mould enterprises. Such products feature large area, thin wall thickness and weak rigidity, and are prone to depression, edge warping, i

  2026/07/23 Chinese Plastic Moulds

• Control of Plastic Product Dimension Deviation Caused by Mould Thermal Expansion Difference

  In the injection molding process, both mould cavities, cores and molding raw materials expand when heated. Owing to the different thermal expansion coefficients of various materials and uneven tempera

  2026/07/23 Plastic Molds

• Cleaning and Maintenance Procedure for Carbon Deposits on Thermosetting Compression Moulds

  During thermosetting compression molding, resin crosslinks under constant high temperature and releases small volatile molecules. After repeated production cycles, carbon deposits accumulate on cavity

  2026/07/23 Injection Mold

• Shrinkage Compensation Design for Molded Household Plastic Decorative Strips

  Household plastic decorative strips are widely used in door frames, cabinet edge sealing, ceiling trim and wall panel decorative moldings. These elongated products require flat appearance, and are mos

  2026/07/22 Injection Mold