• Cost Difference Analysis Between Partial Mold Revision and New Mold Fabrication

  Product upgrading, size correction and structural optimization often occur in injection molding production. Factories adopt two solutions for product modification: partial mold revision based on origi

  2026/08/03 Injection Molding

• Core Structural Design Essentials for TPU Overmolding Molds

  TPU combines rubber elasticity and plastic processing performance. Dual-color hard-soft overmolding and secondary insert overmolding are mainstream molding technologies, yet overmolding easily causes

  2026/08/03 Injection Mold

• Pre-emptive Prevention Measures for Defects of Appearance Plastic Molds

  Appearance plastic parts have strict requirements against pits, flash, weld lines, water streaks and uneven gloss. Remedying defects through mold revision and machine debugging after defective product

  2026/08/03 Plastic Molds

• Core Development Essentials for Gas-Assisted Molds of Deep-Cavity Injection Molding

  Deep-cavity plastic parts always feature deep depth, uneven wall thickness and long narrow ribs. Conventional injection molding frequently causes shrinkage dents, internal shrinkage cavities, heat acc

  2026/08/03 Injection Molding

• Chinese Plastic Mold Complete High‑Gloss Mirror Polishing Procedure

  In China’s plastic mold industry, high‑gloss mirror finishing is essential for manufacturing high‑grade home appliance shells, automotive exterior parts and transparent plastic products. The mirror qu

  2026/07/31 Chinese Plastic Mold

• Anti‑yellowing Surface Treatment for ASA Outdoor‑Part Molds

  ASA material is widely adopted for outdoor home‑appliance housings, photovoltaic accessories and automotive exterior components with outstanding weather resistance. Nevertheless, local yellowing, fogg

  2026/07/31 Plastic Molds

• Filling Balance Debugging Tips for Multi‑cavity Home‑Appliance Molds

  Multi‑cavity molds are widely applied for home‑appliance components to improve output and reduce unit cost. Unbalanced filling frequently appears during trial and mass‑production: inconsistent filling

  2026/07/31 Injection Molding

• Drying and Dispersion Control Specification for MIM Feedstock

  MIM or ceramic powder injection molding feedstock consists of metallic/ceramic powder mixed with organic binder by compounding and pelletizing. Feedstock is highly sensitive to humidity, drying temper

  2026/07/31 Plastic Molds