• Core Design Points of Lifter Mechanism for Plastic Injection Molds in China

  Lifter mechanisms are widely used in injection molds for internal undercut release. They convert vertical ejection force into lateral sliding movement, which is compact and cost-effective compared wit

  2026/10/21 Chinese Injection Molding

• Cooling Channel Optimization of Plastic Molds to Reduce Part Internal Stress in China

  Uneven cooling and temperature gradient are major sources of residual internal stress for injection molded plastic parts. Optimized cooling systems help synchronize solidification speed of melt, reduc

  2026/10/21 Chinese Injection Molding

• Weld Line Improvement of Threaded Caps by Adjusting Gate Position in Injection Molding

  Weld lines appear where two melt flows converge. Lines on thread surfaces reduce torsion strength and cause leakage. Adjusting gate position is an economical modification to transfer weld lines out of

  2026/10/21 Injection Molding

• Rust Prevention Solutions for Long-term Storage Protection of Injection Molds

  Rust forms easily on mold cavity, core, slide and lifter surfaces when molds are stored or idle. Moisture, plastic decomposition residue and corrosive workshop gas will leave pitting corrosion, scratc

  2026/10/21 Plastic Molds

• China How to Carry out Synchronous Debugging of Ejection Mechanism in Plastic Mold Assembly

  The synchronization performance of ejection system is critical in plastic mold assembly. Out-of-sync movement of ejector pins, ejector blocks and reset parts may cause product whitening and deformatio

  2026/10/20 Chinese Injection Molding

• Coil Protector Mold Rusting, Complete Anti-rust Methods for Plastic Molds

  Coil Protector Mold Rusting, Complete Anti-rust Methods for Plastic MoldsCoil protector products are mostly molded by rubber or soft PVC. The mold cavity features tiny structures with dense grooves an

  2026/10/20 Plastic Molds

• Tube Burr Issue, How to Set Clamping Force for Injection Molds

  Tube parts are typical rotary plastic workpieces. Flash along parting surface and flange edge is a common defect during injection molding. Many operators simply attribute flash to insufficient clampin

  2026/10/20 Injection Mold

• Plastic Mold Rectification Ideas for Stress Whitening of Conical Cap Plugs

  Stress whitening is a typical molding defect of conical cap plugs. Under the action of ejection force, residual stress inside the product causes local whitening on the surface, which affects appearanc

  2026/10/19 Plastic Molds